Tree Services

What You Should Know About Professional Tree Pruning

»Posted by on Mar 20, 2019 in Tree Services | 0 comments

Just because you bought new tree loppers it means you can cut tree limbs on your own. Tree pruning may just be more meticulous than tree cutting. You have to know what parts of the tree you have to remove to enhance its health. One wrong move and you may be damaging the tree than preserving it.

Tree branches tend to attach to each other in different ways, such as co-dominantly, collared, and collarless. Each of them requires a specific pruning method so as to prevent branch regrowth and if they’re decayed, limit its spread. If the branches are trimmed improperly, then it may re-sprout, regrow, or cause rotting to the rest of the tree.

Different Types of Tree Cuts

Cutting, pruning, and trimming trees require precision. Arborists and tree specialists spend years learning about the ways to execute this task right. They perform specialized cuts on trees depending on what’s required, such as:

1. Thinning

Thinning is a drastic form of tree pruning as it cuts out an entire limb, branch, or shoot from its point of origin. This is done to revitalize the tree. It removes weak, excessive, problematic, and over-mature growths. When done right, thinning will encourage the growth of new branches that will readily bear flowers and fruits. Thinning is a technique commonly used in bushes, such as roses, to remove the dead parts and renew the shrubs.

2. Topping

Tree topping is the most severe form of tree pruning. This involves removing all its growths and branches, leaving just a few ones attached to the tree trunk. This technique is done on very young trees to train them for trellising, pollarding, or forming espaliers. It is never done on mature trees at all, as it would cause them to die.

3. Raising and Reduction

These two techniques are used to create a certain effect on the tree. Raising the tree will remove the tree’s lower branches to provide clearance for vehicles, buildings, vistas, and pedestrians. Reduction, on the other hand, will reduce its size to provide clearance for the utility lines. Reducing the spread or height of the tree is different from tree topping. Reduction works for mature trees and it has to be done in a special way to maintain the structural integrity and form of the tree.

4. Dead-wooding

Dead wooding is a technique used to remove certain branches of the tree. It’s the usual tree pruning process used to remove branches that are deficient, infected, and damaged. Dead branches will affect the rest of the tree because the decay may possibly spread. Dead wooding trees should be done safely because it’s possible that you’re dealing with branches that will fall off without notice and cause damage to people and properties.

5. Thinning and Lifting

Thinning and lifting are done on the crowns and canopies of trees. Thinning increases light and reduces wind resistance. Lifting, on the other hand, removes the lower branches to achieve the desired height.

These are the techniques that arborists and tree specialists perform in order to provide your trees with the much-needed care. Hire only the professionals to get the results that you wanted.

read more